I tried to open my map in bo3 radiant which works fine, but when I compile changes in radiant stop working ingame although the compiler says nothing.

Incase it was just my map, tried just adding a single brush prefab from waw radiant into bo3, that didnt work either.

Is there any proper way to load waw maps?

The way i've seen people do it is to not load it as your main map but just load it as a prefab and put it into a map created with the bo3 launcher. If you aren't already doing this its worth a try.

The way i've seen people do it is to not load it as your main map but just load it as a prefab and put it into a map created with the bo3 launcher. If you aren't already doing this its worth a try.

I tried that too.

I also tried putting it in as a prefab and then stamping it, didnt work either.

I was able to port my map from WAW to BO3 with no problems.

Do you have any custom textures/models that you didnt port into bo3? If there is any missing, the map will not compile at all.

I was able to port my map from WAW to BO3 with no problems.

Do you have any custom textures/models that you didnt port into bo3? If there is any missing, the map will not compile at all.

lol that would do it, every texture and model is custom.

lol that would do it, every texture and model is custom.

Ya thats the problem then. I had to do the same thing in order to even load up the map. Pretty easy to do it though. Theres a tutorial on the UGX wiki

Ya thats the problem then. I had to do the same thing in order to even load up the map. Pretty easy to do it though. Theres a tutorial on the UGX wiki

I feel somewhat like an idiot but where did the 'mark as best answer' button go? 

I feel somewhat like an idiot but where did the 'mark as best answer' button go? 

Hmmm. It seems like the "Mark as Best Answer" button is not on this board. I have notified trem/delta of it

Save a duplicate copy of the waw map, except without textures or models/entities. Then load into Radiant Black, and retex/ add bo3 assets and entities back in.