ok so i was wondering if you can set up a trigger to activate 2 models that link to 2 different script_structs
i want a gate to go right, and than another gate go left when the trigger is purchased.
If you know how to do this please reply back thanks in advance!

---

Double Post Merge: April 25, 2015, 10:50:23 pm

---

or if this is even possible

ok so i was wondering if you can set up a trigger to activate 2 models that link to 2 different script_structs
i want a gate to go right, and than another gate go left when the trigger is purchased.
If you know how to do this please reply back thanks in advance!

---

Double Post Merge: April 25, 2015, 10:50:23 pm

---

or if this is even possible

If you want this to be a door, then just make it like you would a door, but make two seperate ents, with different script_vectors.

If you want it to just be something to do in the middle of a zone and not activate any zones then you can:
Radiant:
Make the two gates script_models, or script_brushmodels
Make two script_structs at the position you want the gates to move to
Set up one struct as the target of one gate, select gate, then struct, then press W
Repeat previous step for other gate.
Add a trigger_use, select it and then one of the gates, press W
Select the trigger again and select the other gate, and press W
Make a targetname kvp for the trigger, i.e. gates


Script:
Write a script that gets an array of ents with targetname kvps of gates.
Then waits for trigger
Then gets array of target ents and threads another function on each
Then in the new function get the target struct and use a moveto(struct.origin,1);

You may want to call connectpaths on each gate as well. You may need to solid and notsolid the gates or use an additional clip brush also.

ok i will try that thanks